Building or modding a keyboard means pulling keycaps, pulling switches, opening a case held by a dozen small screws, and keeping those screws from disappearing under the desk. Gateron's tool kit covers all of it in a single case: an electric precision screwdriver with twenty bits, a pair of fine tweezers, a pry tool for prising cases and plates apart, the Twins keycap and switch puller in one, and a magnetic tray that holds every screw you take out until it is time to put them back. The case itself is a hard shell with a backlit lid, so it looks like a piece of kit rather than a plastic tub.
The screwdriver is the heart of it. Case screws on a custom keyboard are small, there are a lot of them, and they strip easily. An electric driver takes them out and puts them back at a steady speed with one press of the button, and you finish the last turn by hand. The bits are S2 tool steel, 4 mm hex and 28 mm long, and the set runs well beyond keyboards: Phillips, flathead and hex for cases and plates, plus Torx, pentalobe, tri-point and tri-wing for laptops, phones, controllers and consoles.












